Installation for Rear Disk Conversion for S30

 

       Installation for Rear Disk Conversion for S30

 Take these instructions to your mechanic. Do not try to install a brake system unless you are mechanically inclined. Silver Mine Motors is not responsible for any part failures due to miss installed brake upgrades.  

  1. remove wheel
  2. remove brake drum
  3. Remove all shoes, springs, piston, etc (the whole brake system).
  4. Now this is the time to make a decision.
    1. Use a hand grinder to cut off your brake backing plate (this is the easy way)
    2. Remove your stub axel, (which enables you to change your old wheel bearings) I recommend this route unless you have already changed your wheel bearings. You should be mechanically inclined to do this.
  5. Bolt on your new caliper bracket to the axel housing.
  6. Take new caliper and hook up e-brake line. In order to hook up the e-brake line you must use the old bracket connection piece that came with the cars stock e-brake system. It is the piece that use to connect the actual metal cable to the old e-brake (lever) system. It has a pins and cotter pin holding a small cylindrical piece of metal to a square metal piece with a slot that holds the metal cable to the square metal piece.
  7. The e-brake cables will need to have the original mounts moved (where they branch over the differential) to allow additional slack to properly attach to the caliper.
  8. Make sure the piston has not moved out, and don’t pull on the e-brake yet.
  9. Now connect the cars stock hard brake line to the new steel braided brake line.
  10. Connect the banjo connection of the new brake line to the new caliper. Make sure the brake lines will not rub on any suspension parts through the suspensions full travel range.
  11. Put the new brake pads in the new caliper.
  12. Blead the rear brakes with a friends help.
  13. Now you can celebrate, you’re done! Congratulations and enjoy the new brakes!

 

 

 

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>